Why does my washing machine keep draining? Once the water level gets down again, it will start to fill and then drain again, etc. After 1 minute, plug your machine back in, then open and close the door 6 times in 12 seconds to signal the computer to reset. The washing machine drain hose goes down about two feet into the plumbing drain standpipe. What's the clicking sound from my Hydrowave washer? What do I do if my washer is leaking? (In some machines, the drain hose may simply be clamped onto the side of a washtub, though this is not an acceptable practice anymore.) Make sure there are no cracks and damages. So if the tub is filling past the time it ought to be, it could be a result of a broken water inlet valve. My top load washer is making noise during the cycle. Washer starts agitating immediately when washer starts filling, also starts filling at end of spin cycle. During the wash cycle the washing machine is over filling or water is constantly going into the machine. If the water is backing up there, it’s a sign that the problem is in the plumbing. Second time occurrence for this Kenmore 800 Series washer, Both times fixed with W10248240 Temp/Load Sensor Switch. Why does my Hydrowave washer hesitate after it fills with water? If you can see the water levels in the drum are way too high and your washing machine is definitely overfilling try here overfilling. You should thoroughly inspect the air dome hose. This would be rare though. Are these normal sounds? The air dome tube can be a reason the issue in that case, if your washer keeps draining while filling. If water keeps coming in, then the water inlet valve is broken. If your washing machine drains while filling, check and make sure that the washer’s drain hose isn’t too far into the standpipe as there needs to be an air gap to prevent premature draining. ... To determine where the clog is located, first, fill the washing machine with water. If the tub keeps filling, you have a mechanical problem with the water inlet valve and it needs to be replaced. But never does it start the wash cycle once the desired water level is reached. Switch lasted 4.5 years the first time, four years this time. Why is my washer not draining? The washing machine drain box is where the lines and hoses from your washing machine connect to your home’s plumbing. Water comes into your washing machine for the wash and rinse cycles through the water inlet valve. After having sealed the one end of the hose, blow air into the opposite end. The washing machine detects the loss of water and keeps filling. If your washer continues to fill during a cycle, the water inlet valve could be at fault. The washing machine will fill up completely to the desired level and then rather than start to wash (agitate), it will drain. Unplug the washer when the tub’s finished filling. If the siphoning wasn’t triggered, the washer would overfill and flood. The kitchen and washing machine share the same drain Discard the air dome tube and douse it into the bucket with water. To verify that the valve is at fault, unplug the washer when the symptom occurs. When there is enough water in the tub, unplug the washer. Additionally, check and make sure that the bend in your drain hose is above the height of the washing machine. Below are some of the most common causes of a washing machine back up. Why does my washer not fill? Observe the washer’s fill cycle. Meanwhile, turn off the faucet to the household water supply so the washer doesn’t cause a flood. To fix a washing machine that stops mid-cycle, try a master reset by first unplugging the washing machine to reset the computer. The water valve may be jammed open. If the washer continues to fill, then the water inlet valve is defective.